10
4
Adjusting the light timer
NOTE:
The light timer (E) controls the amount of time the
light (B) will stay on full bright after all motion has stopped.
The timer is adjustable from 5 seconds to 5 minutes.
□
To increase the time, turn the control dial (E)
toward the “5 Min” position.
□
To decrease the time, turn the control dial (E)
toward the “5 S” position.
W
TE
ST
5S
O
FF
5M
in
Care and Cleaning
□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Periodically clean the solar panel with a soft cloth and warm water. Do not hose spray. Keep the panel clear of
snow and leaves. Make sure trees and other objects do not block sunlight from the panel.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.
□
If not to be used for several weeks, turn the unit OFF. Store it with the panel connected and where the panel
can gather sunlight.
Troubleshooting
Problem
Possible Cause
Solution
The light will not come on.
□
The control dial is set to the OFF
position.
□
Turn the control dial to select an
amount of time for the light timer.
□
Batteries are dead.
□
Replace the three “C” alkaline bat-
teries.
□
Solar panel positioned wrong.
□
Position and angle solar panel so that
it gets plenty of direct sunlight for
most of the day, if not the entire day.
□
Daylight turn-off (photocell) is in
effect.
□
Recheck after dark.
□
Motion sensor is positioned
wrong.
□
Reposition light so motion sensor
is positioned toward the area of
movement.
□
Surrounding air temperature is
greater than 122° F (50° C) or less
than -4° F (-20° C).
□
The light will operate normally inside
the specified temperature range.
Light is not as bright as
normal.
□
The rechargeable solar battery is
low and the light is running off of
the three “C” backup batteries.
□
Once the rechargeable solar battery
is sufficiently recharged, the light will
come on at full brightness.
There is a red blinking light
inside the motion sensor.
□
The three “C” batteries are run-
ning low on power.
□
Replace the three “C” alkaline bat-
teries.
B
E
Operation (continued)
