8
Installation (continued)
8
Mounting the light fixture
□
Slide the rear of the light fixture (B) down onto
the mounting plate (D) until it snaps into place.
W
UP
9
Mounting the solar panel
IMPORTANT:
Caulk around the base and on top of the screw heads
after installation.
□
Place the solar panel (F) against the mounting
surface and mark the mounting holes.
□
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (AA)
through the base and into the mounting
surface.
□
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (BB) and attach the
base using the two mounting screws (AA).
10
Adjusting the solar panel
□
Rotate the solar panel (F) to the desired angle.
IMPORTANT:
The solar panel (F) must receive as much direct
sunlight over the course of the day as possible. Keep in mind that
shadows may block the sunlight from reaching the solar panel (F)
during the day.
11
Connecting the solar panel
to the light fixture
□
Carefully route the solar panel cable (8) to the
light fixture (B). Remove the rubber plug (9)
from the bottom of the light fixture (B) and
insert the end of the cable (8) into the opening.
IMPORTANT:
Turn the control dial (E) on the side of the sensor (C)
to the OFF position and allow the battery to charge with 3 to 7 days of
full sunshine before testing.
NOTE:
Wrap any excess solar panel cable (8) around the
cord management system (G) located on the rear of the
solar panel (F). Leave enough loose cable (8) to form a
drip loop (10).
E
W
B
D
AA
F
E
C
9
10
B
8
G
F
F
