Defi ADVANCE ZD, Руководство по эксплуатации

Страница: 95 / 112

8 -7.・Warning・setup・mode
Warning values can be set.
※ Warning function is not applied to either speed or volt.
⇒ Refer to 8 -6-2-1. Warning display
■ Factory default settings of warning values
Gauge
Default
setting
Unit
Setting range Warning
condition
Warning
output
Minimum Maximum
Turbo/ 100 kPa -100 200 Set value
and above
ON
In-mani press 14.5 PSI -14.5 29
Tachometer 7000 RPM 300 11000
Set value
and above
ON
Oil press
120 kPa 0 1000 Set value
and below
ON
17.5 PSI 0 145
Fuel press
150 kPa 0 600 Set value
and below
ON
21.8 PSI 0 87
Oil temp
125 ℃ 0 150 Set value
and above
ON
257 °F 32 302
Water temp
105 ℃ 0 150 Set value
and above
ON
221 °F 32 302
Exhaust temp
850 ℃ 0 1100 Set value
and above
ON
1562 °F 32 2010
※ Depending on vehicle type and/or condition, vehicle may be damaged
even if the value is under the factory default setting value of warning (over
the factory default setting value of warning in case of oil pressure and fuel
pressure). Be sure to consult store professional to set warning values.
※ Regarding turbo/in-mani pressure:
ZD・cannot・display・turbo/in-mani・pressure , but the warning values can be
set if turbo sensor is installed. The warning buzzer sounds if the setting of
warning buzzer is ON, and warning signal is output if warning output is ON,
but
there・is・no・warning・display・for・turbo/in-mani・pressure .
94