Defi ADVANCE ZD, Руководство по эксплуатации

Страница: 67 / 112

7 -4.・Installation・of・ZD・and・wiring・of・meter・wire
1. The bolt holder and the hexagon head bolt
are inserted into the slit of brace. And the
knob is temporarily fastened.
2. Insert convex part of the mounting bracket
over the legs of the brace. And Attach the
mounting bracket to the brace with the
bolt, nut and washer included in the kit as
shown in the figure 1.
3. Cut the buffer into 30x85mm (2 pieces) and
attach them to the backside of ZD (2 places)
as shown in figure 2.
4. Connect the meter wire to the connector
on the backside of ZD.
5. Insert the bolt holder of brace into the
groove of ZD and then fasten the knob as
shown in figure 3. If it is too tight-fitting to
insert, unfasten the knob once.
6. Adjust the angle and location to attach.
The mounting bracket is bendable to fit on
the place to attach.
7. Attach double sided tape on backside of
the mounting bracket (4 places) as shown
in figure 4. Fix ZD on the place where you
intend to attach it.
8. Confirm the knob and bolts are fastened
firmly and ZD is fixed firmly.
9. Carry out the final confirmation according
to the manual of ADVANCE Control unit.
⇒ Refer to manual of ADVANCE Control unit.
【Fig.1】Fix brace on bracket
【Fig.3】Insert brace to ZD
【Fig.4】Attach tape on bracket
17
30
Screw holes(Φ4.4mm)
66