DeepSea Power & Light SeaLite Lumos 1000, Руководство оператора

Страница: 4 / 15

SeaLite
®
Lumos
Operator’s Manual
4
Safety Symbol
In this operator’s manual and on the product, safety symbols are used to communicate important
safety information. This section is provided to improve understanding of these symbols.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to
avoid possible injury or death.
DANGER
indicates a hazardous situation which, if not avoided, could result in death or serious injury.
WARNING
indicates a hazardous situation which, if not avoided, could result in damage to the product or bodily harm.
CAUTION
indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE
indicates information that relates to the protection of property.
This symbol means read the operator’s manual carefully before using the equipment. The operator’s manual contains important information
on the safe and proper operation of the equipment.
This symbol means always wear safety glasses with side shields or goggles when handling or using this equipment to reduce the risk of
eye injury.
This symbol indicates the risk of electrical shock.
DANGER
!
WARNING
CAUTION
NOTICE
General Notes and Warnings
You may run your SeaLite
®
Lumos in air. As the light
heats up you will notice that the output will diminish. This
is normal, and the light will return to full brightness once
it is submerged and allowed to cool down.
DANGER
When the SeaLite ® Lumos is operated in air the body
may reach temperatures in excess of 65° C. These
temperatures may be enough to cause burns if the light
is handled without protective clothing.
Do not operate any high voltage electrical equipment in
or around water without using a Ground Fault Interrupt
circuit (GFI) and an isolation transformer, especially
when divers are in the water.
WARNING
Do not clean any part of the light head with any type of
alcohol.
There should be no reason to ever open the body of
your SeaLite
®
Lumos light. There are no user serviceable
parts inside your new underwater light. Your SeaLite
®
Lumos was thoroughly pressure tested prior to leaving
the factory to confirm the integrity of the complete
assembly. Opening the housing may cause potential
problems when resealing.
Pre and Post Dive
Inspection
Check to make sure that the rear bulkhead connector is
secure before deployment.
Check the following areas for previous damage, wear or
corrosion: rear bulkhead connector, power cable, front
window.
Rinse your SeaLite
®
Lumos in fresh water after use in
saltwater.
DANGER
After each deployment, carefully check to make sure
the light is operational and has not flooded. If it gets
flooded, upon surfacing, the light can become internally
pressurized, which may be potentially dangerous.
Additionally, if the power remains on when the light has
partially flooded, it is possible for electrolytic generation
of an explosive mixture of hydrogen and oxygen gases.
If a light appears flooded upon removal from the water,
it should be treated as potentially dangerous. Point the
light away from persons and valuable equipment and
make sure that the power is disconnected. See the
Flooded Light Repair procedure for more information.