How to replace an Alliance interface
It may be necessary to replace an interface for your Alliance machine. The
interface is the location where your Alliance mixing lid will engage the drive
system of your Alliance mixing machine.
To remove an interface:
1. Turn off the power to your Alliance mixing machine.
2. Access the interior of the mixing shelf where the interface is located.
(See How to repair your machine without disassembling it)
3. Using a flat screw driver push into the slots that secure the interface to the
mixing shelf on each side. (See Figure 1)
4. Pull the loosened interface down and away from the mixing shelf.
Note: The interface may break or crack during removal.
To install a new interface:
1. Place the back tab of the interface into the opening on the mixing shelf.
2. Push up on the front underside of the interface until the two tabs are snapped
into place. (See figure 2)
Figure 1
Alliance Interface
PN# 5752B
Mix Shelf
Back Tab
Locking Tab
Figure 2
