USE R M ANU AL
TOUCHSCREEN 2.1
4
SEPTTEMBER 12, 2017
Introduction
The
Touch Display is used to communicate to Supervisaire control board as local
and/or remote operator panel.
Touch display features:
•
Large, easy to use color display with touch screen interface
•
SD card for storing menu structure and backup files
•
Easy firmware and menu upgrades
•
Backup/restore system configuration data to/from the SD card
•
Save system log files to the SD card when not connected to WebSentry®
Installation
The Touch Display communicates over a RS-485 serial port. The display is
equipped with a RJ-45 socket so it is recommended to use a CAT5 or CAT6 cable
between display and control
board.
Supervisaire hardware has a dedicated RJ-45 socket intended for connecting
the touch display to the board. If the display is mounted in or near the system, all
you need is a standard Ethernet cable with RJ-45 plugs on both ends. If you
want to add a second display in a remote location, you must use header J8 for
this purpose (see page 5).
Below is a description of different ways to wire the touch display to the
Supervisaire control board.
