Technical documentation
20140208BA
AFMS3000
Tel.: +49 (0)4105 / 65 60 – 0 *
DECKMA GmbH
* Fax: +49 (0)4105 / 65 60 – 25
Email:
www.deckma-gmbh.de
Operating instructions
Version 1.0
2018/03/17
page 16 of 24
After about 30 seconds (without any further key being pressed), the main panel (AHT) returns
automatically to the main menu screen or it will be updated only (e.g. in TEST mode).
2.8.1.
Show firmware
This menu tab enables the firmware of all modules to be shown. It can be reached from the main
menu by selecting the sub-menu tabs:
è
Service
è
System Status
è
Firmware
2.8.2.
RESET of the AFMS
This menu entry enables a restart of the whole AFMS system. It can be reached from the main menu
by selecting the sub-menu tabs:
è
Service
è
System Reset
Three RESET functions are available:
1. Reset with deleting all (with password): The previously accumulated fire alarms and
faults will be all deleted and the system is restarted.
2. Reset with hold all: The system will be only restarted (holds all data).
3. Reset with new init modules (with password): All fire alarms and faults will be deleted,
the modules and detectors are newly initialised and the system is then restarted.
In case the restart does not happen, it is possible to use the "Reset" key on the main module to
activate a restart manually.
2.8.3.
Set date and time
This menu entry enables the settings of time and date. It can be reached from the main menu by
selecting the sub-menu entries:
è
Service
è
Settings
è
Set Date and Time
2.8.4.
Perform lighting test of the illuminated fields
This menu entry enables a test of the lighting of the illuminated fields to be performed. It can be
reached from the main menu by selecting the sub-menu entries:
è
Service
è
Settings
è
Lamp Test
