MG3 & MG4 | V1 |
Page 14
FINAL STEPS:
TORSION BRACE + BOTTLE
OPENER
• Slide torsion brace under center vert and tailgate ammo cans.
NOTE:
If you jumped the gun and tightened the J-hooks when installing, loosen them.
• Loosely install:
• Two bolts through the end holes in torsion brace into ammo cans; BAG
S1.
• Two bolts through the bottom bottle opener holes and torsion brace into center vert; BAG
S1.
• Two 1/2" length bolts through upper holes in bottle opener into center vert; BAG
FINAL MID.
• Align bottle opener to edges of center vert and tighten four bottle opener bolts.
• Tighten end bolts into tailgate ammo cans.
• Finally.....Tighten the J-hooks! DO NOT OVER TIGHTEN, just make snug. Make sure the gap between the
sidewall of the bed and the deck on the driver side is equal to gap on the passenger side.
TORSION BRACE
BOTTLE OPENER
1/2" LENGTH BOLTS
BAG FINAL MID
HELPFUL TIP
: Bottle opener goes
outside
of torsion brace.
