Align shim to channel in floor shown 3” from
cabside panel of bed (red).
Align shim to channel in floor shown. Place
shim 7" from rear of bed (red).
3”
7 "
A
B
➡
CAB
DETAIL A
DETAIL B
MG3 & MG4 | V1 |
Page 2
PREP BED:
SHIMS
•
2 SHIMS
that look like this can be found in your hardware kit.
• Using the information below:
1) Clean the bed surface where the shims will be located. Isopropyl alcohol (do not drink) is recommended.
2) Remove tape film and apply shim with the strength of 1000 men a.k.a push really hard.