12G-CROSS OPERATING MANUAL VERSION 1.0
Copyright © 2020 Decimator Design Pty Ltd, Sydney, Australia
E&OE
3
Main Menus
Upon power up, the unit will start in the Main Menu pointing to Input Status.
The Main Menus are:
1.
Input Status
2.
Control
3.
Scaling
4.
Aspect
5.
Audio
6.
Colours
7.
Setup
Press the < and > buttons to move left or right through the menus.
To enter into a menu press the ENTER button.
Notes:
1.)
Defaults are highlighted in yellow.
2.)
When an option is changed, a highlighted
S
will appear in the top right of the LCD screen and will
disappear when the options are saved after 10 seconds. Avoid powering down the unit during this
time.
3.)
You can always return to the Main Menu by pressing the BACK button twice.
4.)
As you move through the menus changing parameters, they will be instantly applied to the unit.
5.)
Scaler and DUC (Down Up Cross conversion) are used interchangeably in the MENUs.
Input Status:
(Has no SUB-MENUs)
S:3GB 1080p59.94
H:ED 480p59.94
G:HD 1080i50
D:12G 4Kp50
Current SDI input format
Current HDMI input format
Current Genlock input format
Current Scaling output format
The input shows the current SDI and HDMI input status as well as the DUC output format status.
Control:
(Has SUB-MENUs)
Control
SDI OUT SOURCE
SDI IN
Main Menu
<==
Sub Menu
Parameter Window
When highlighted in the Main Menu, press the ENTER button to enter this sub-menu.
Press the < and > buttons to move left or right respectively through the 9 menus below and press the BACK
button to go back to the Main Menu when finished.
The current value for each Sub Menu is shown in the Parameter Window.
1. Control / SDI OUT SOURCE (Parameter)
This is the current source for the SDI output.
When the sub menu is highlighted, press ENTER to toggle through the following sources:
1.)
SDI IN
2.)
HDMI IN
3.)
Scaler
Output from Scaler
2. Control / HDMI OUT SOURCE (Parameter)
This is the current source for the HDMI output.
When the sub menu is highlighted, press ENTER to toggle through the following sources:
1.)
SDI IN
2.)
HDMI IN
3.)
Scaler
Output from Scaler
