TREK1000 User Manual
© Decawave 2016
This document is confidential and contains information which is proprietary to
Decawave Limited. No reproduction is permitted without prior express written permission of the
author
Page
29 of 54
Figure 30: User Interface: Tag Table Pane
– Geo-Fencing Mode
The field in the Tag Table Pane are:
Tag ID/Label
Show/Hide the Tag label on the Display
Customize the label text
– click on the label to edit
X (m)
The x distance of the Tag from position (0, 0)
Y (m)
The y distance of the Tag from position (0, 0)
Z (m)
The z distance of the Tag from the ground
Requires the Anchor heights to be entered correctly
R95 (m)
A measurement of precision of a Tag
Only meaningful for stationary Tags
Enable or disable this calculation
Anc 0 range (m)
Measured distance between antennas of Anchor 0 and Tag
Anc 1 range (m)
Measured distance between antennas of Anchor 1 and Tag
Anc 2 range (m)
Measured distance between antennas of Anchor 2 and Tag
Anc 3 range (m)
Measured distance between antennas of Anchor 3 and Tag
A 4
th
Anchor is not required in the standard TREK setup
6.5 Settings Pane
The settings pane appears to the right of the User Interface and has 3 tabs:
1. Configuration Tab
2. Floor Plan Tab
3. Grid Tab
6.5.1 Configuration Tab
The configuration tab contains general settings for use case modes and showing/hiding
features.
Switch between ‘Tracking/Navigation’ mode and ‘Geo-Fencing’ mode using the
checkboxes
In Geo-Fencing mode:
o
Set 2 zone perimeters on the Display Pane
– enter the desired perimeters in
metres
o
Select ‘Alarm Outside’ or ‘Alarm Inside’ depending on whether the no-go area
is far from or near to the Anchor
Use Auto-Positioning:
o
When ‘Use Auto-Positioning’ is checked, the system ignores the x, y anchor
co-ordinates that the user has entered and automatically calculates the
positions of the anchors.
