Front panel layout
Dip-switches (10-way and 6-way)
1.
Flip 10-way and 6-way dip-switches to set some functions and modes for user’s desired effects.
DMX input
2.
3-pin XLR male connector or terminal. Connect a universal DMX controller into this input for receiving
DMX values or DMX signals.
DMX output
3.
3-pin XLR female connector or terminal. Connect to next DMX fixtures for sending DMX values or DMX
signals.
Output
4.
6 terminal output connectors, allows a maximum load of 3 x 350mA per output and the maximum
amount connector load distributed over all outputs must not exceed 6A.
Physical dimensions
Termination reduces signal errors and avoids signal transmission
problems and interference. It is always advisable to connect a
DMX terminal, (Resistance 120 Ohm 1/4 W) between PIN 2 (
DMX-) and PIN 3 (DMX +) of the last fixture.
Figure 4
4.Product Layout & Functions
1. Dip Switches(10-way and 6-way):
Flip 10-way and 6-way Dip Switches to set some functions and modes for user's desired effects.
2. DMX Input:
3-Pin XLR male connector or terminal. Connect a universal DMX controller into this input for receiving DMX
values or DMX signals.
3. DMX Output:
3-Pin XLR female connector or terminal. Connect to next DMX fixtures for sending DMX values or DMX
signals.
4. Output:
6 terminal output connectors, allows a maximum loads of 3x350mA per output and the maximum amount
connected loads distributed over all 6 outputs must not exceed 6A.
-3-
4.1 Front Panel Layout
1
2
3
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data Compliment(-signal)
Data True(+signal)
Not Used
Not Used
3-Pin XLR Female(Out)
Pin 1
Pin 2
Pin 3
5-pin XLR Male(In)
Pin 1
Pin 2
Pin 3
Pin 4 - Do Not Used
Pin 5 - Do Not Used
5-Pin XLR DMX Connectors.
Some manufactures use 5-pin XLR connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures may
be implemented in a 3-pin XLR DMX line. When inserting standard 5-pin XLR connectors in to a 3-pin line a
cable adaptor must be used, these adaptors are readily available at most electric stores. The chart below
details a proper cable conversion.
4
2
3
1
6.Technical Specifications
Power Input: AC110-120V(3.2A)/AC220~240V(1.2A)-50/60Hz
DMX In: 3-pin male XLR connector or terminal
DMX Out: 3-pin female XLR connector or terminal
Output: 6 output terminals, 3x350mA per output
Dimension: 285X176X67mm
Weight: 2.2kg
*Please Note:
Specifications and improvements in the design of this unit and this manual are subject to change without any
prior written notice.
Physical Dimensions
Front View
Back View
Top View
High Power DMX Controller TV
-8-
