Deagostini ModelSpace Hummer H1, Инструкция по сборке

Страница: 11 / 24

HUMMER H1: STEP BY STEP
9
11
77
88
22
44 33 55
66
Hold the tire and wheel, as shown. The
wheel must enter the tire through the
wider hole. Working around the wheel, pull the shoulder
of the tire back slightly to help ease it into
the groove on the inside of the rim.
Turn the wheel assembly over
and position the other side
of the tire into the groove on
the other side of the wheel.
Wash the tire with some dishwashing soap, paying especially
close attention to the areas that will be in contact with the
wheel rims.
Ease the sidewall back a little,
creating a small gap between
the tire and the wheel rim,
then squeeze a small amount
of instant adhesive into the
gap. See the Tip box on the
right for the recommended
technique for applying
the glue.
When the glue is dry, turn the wheel assembly over and
repeat Step 7 for the other side.
While waiting for the tire to dry, use wet and dry paper to
remove the paint from the rims of the wheel (which was
provided in Stage 1). This will help with adhesion.
Insert the wheel into the tire.
Assembling the wheel
Tip
When applying instant
adhesive to the wheel,
follow the order shown
in the photo. This
method will secure
the wheel to the
tire without the tire
becoming distorted.