CONNECTING THE SERVO CABLE
3
Take either end of the connector cable saved from the
previous stage and carefully fit it in one of the two
sockets circled in red. It does not matter which one.
Gently push it until it locks in place.
1
Use a screwdriver to undo the four screws securing the
cover of the servo, and take each one out.
4
Carefully feed the free end of the cable up through the
circular hole in the servo cover. Make sure that the cover
is the right way up.
5
Fit the cover onto the servo casing, then turn the servo
over and insert two of the screws you removed in Step 1.
Tighten them lightly, as you will be removing them again
in this assembly.
2
Carefully lift the cover away from
the other side of the servo.
BE CAREFUL!
Try to avoid
touching the
circuit board
or electronic
components
when you remove
the cover from
the servo.
TIP!
If you chose not to fit the protective pad in Stage 15, you can fit it
now, which will help to secure the connector in place.
82