17
Testing Your System
NOTE: If you are going to perform a System Test, call your Monitoring Station to inform them when you begin and
also when you end the test.
Testing Your Keypad Sounder and Siren
The System Test provides several system tests, and a two-second check of the keypad sounder and bell or siren.
1. Press
[Master
Code]
.
2. The following will occur:
- The system activates all keypad sounders and bells or sirens for two seconds. All keypad lights turn ON.
- LCD5500Z keypads will light all pixels
- The Ready, Armed, and Trouble LED’s will flash for the duration of the test
3. To exit the function menu, press
.
Testing Your Entire System
All smoke detectors in this installation must be tested by your smoke detector instal er or dealer once a year to
ensure they are functioning correctly. It is the user’s responsibility to test the sys em weekly (excluding smoke
detectors). Ensure you follow all the steps in the ‘Testing Your System’ section above.
NOTE: Should the system fail to function properly, call your installation company for service immediately.
1. Prior to testing, ensure that the system is disarmed and the Ready ligh is on.
2. Press
and close all zones to return the system to the Ready sta e.
3. Perform a System Test by following the steps in the previous ecti n.
4. To test the zones, activate each detector in turn (e.g., open each door/window or walk in motion detector
areas).
PK55xx/LCD5500Z keypads
will display the follow ng message when each zone (detector) is activated:
“Secure System Before Arming < >”, “Secure System or Enter Code” or “Secure or Arm System”. Use the
keys to view which zones are open The message will disappear when the zones are closed.
On an LCD5501Z keypad
, the display says
pen” when any zone (detector) is activated. To see which
zones are open, press
. The keypad w l scroll the numbers of all open zones.
On a PC55XXZ keypad
, the zone ligh urns ON when the zone (detector) is activated. The zone light turns
OFF when the zone is closed (e.g door or window closed).
NOTE: Some features described above will not be functional unless enabled by your installer. Ask your installer which
features are functional on your ys em.
Walk Test Mode
The installer can initiate a Walk Test mode for the system. While in Walk Test mode, The Ready, Armed, and Trou-
ble LED's will flash to indicate that Walk Test is active. When the system automatically terminates the Walk Test
modes, it will annunciate with an audible warning (5 beeps every 10 seconds), beginning five minutes prior to the
termination of the test.
Allowing Computer Access To Your System
From time to time, your installer may need to send information to or retrieve information from your security sys-
tem. Your installer will do this by having a computer call your system over the telephone line. You may need to
prepare your system to receive this ‘downloading’ call. To do this:
1. Press
[Master code]
at any keypad. This allows downloading for a limited period of time. During
this time, the system will answer incoming downloading calls.
For more information on this feature, please ask your installer.
http://www.ealarm.com.my
