DCS -DRH48N, Инструкция по использованию, уходу и установке

Страница: 16 / 44

USING THE HEATER
LIGHTING INSTRUCTIONS
TO LIGHT HEATER
Upon installation of the heater and completion of the gas line and electrical supply to each heater, follow the
steps below for Lighting Instructions. Lighting instructions are also provided on the control panel of the heater.
Turn gas and power to “ON”. The burner should light within the first 4 seconds. If not, the flame sensor will shut
off the mini-igniter. The unit will attempt to light 3 times before “locking out”. During initial installation, this
will happen if the gas line is not purged. To reset the control, shut off the power to the unit and wait 5 minutes.
Turn power back to “ON” position. This will allow for 3 more lighting attempts.
TO START HEATER
1. Turn manual gas valve to “ON” position.
2 . Turn electrical supply “ON”.
TO SHUT DOWN HEATER
1. Turn electrical supply “OFF”.
2.
Turn manual gas valve to “OFF” position.
WARNING!
If burner fails to ignite, shut down electrical power and wait 5 minutes before turning power “ON” to allow any gas
to dissipate.
A remote control accessory (DRH-RMT) is available. To order contact Customer Care at 1-888-936-7872.
WARNING!
Do not attempt to light this heater by hand.
14