DCS BGB30-BQR Series Скачать руководство пользователя страница 19

Страница: 19 / 80

Connection:

1/2" NPT male with a 3/8" Flare adapter (included). LP Hose with a quick disconnect and fittings are

included.

Operating pressure:

11.0" W.C.

CAUTION!

Before connecting LP tank to regulator, check that all grill burners, side burners, and rotisserie valves are in the OFF
position and open grill lid.

To connect the LP regulator/hose assembly to the tank/valve assembly, first make sure the main valve on the
tank is completely closed. Although the flow of gas is stopped when the Type 1 system is disconnected as part
of its safety feature, you should always turn off the LP tank main valve (Fig.23) after each use and during
transport of the tank or unit. Insert the regulator inlet into the tank valve and turn the black coupler clockwise
until the coupler tightens up.

Do not overtighten the coupler.

Turn the main tank valve on and turn the burner

control valves on the unit to the “HI” position for about 20 seconds to allow the air in the system to purge, turn
valves off and wait 5 minutes before attempting to light the burners.

To disconnect the coupler, first make sure the main tank valve is turned off. Grasp the coupler and turn counter
clockwise. The inlet will then disengage. Remove the inlet from the tank valve opening if it has not already
done so when it disengaged. Your local LP filling station should be equipped with the proper equipment to fill
your tank.

LP TANK REQUIREMENTS:

A dented or rusty LP tank may be hazardous and should be checked by your LP supplier. The cylinder that is
used must have a collar to protect the cylinder valve.

Never use a cylinder with a damaged valve. Always

check for leaks after every LP tank change. The LP gas cylinder must be constructed and marked in accordance
with the specifications for LP gas cylinders of the U.S. Department of Transportation (DOT or CAN/CSA-B339) and
designed for use with a Type 1 system only. Do not change the regulator/hose assembly from that supplied with
the unit or attempt to use a Type 1 equipped regulator/hose assembly with a standard 510 POL tank/valve
assembly. The cylinder must be provided with a shut-off valve terminating in a LP gas supply cylinder valve
outlet specified, as applicable, for connection Type 1.

If the appliance is stored indoors, the cylinder must be

disconnected and removed from the appliance. Cylinders must be stored outdoors in a well-ventilated area
out of the reach of children.

Note:

When an LP unit is being directly connected to an LP house sys-
tem, you must follow the natural gas hook up guidelines. The
installer must provide the proper gas regulator to reduce the gas
flow to 11” W.C.

Note:

The Grill comes with the LP Regulator/Hose assembly installed at
the factory. The assembly, along with the entire Grill system, is
leak tested. Do not remove the Regulator/Hose assembly from
the Grill during installation.

WARNING :

1. Do not remove the Grill from the pallet until you are ready

to install.

2. Do not place the Grill directly on the ground or any other flat surface without support. This will prevent

damaging the regulator/hose assembly by the weight of the grill.

3. Check the hose, regulator and connectors for damage. Look for cracks, abrasions, brittleness, holes, dents

and nicks.

4. Do not attempt to remove, repair, or replace the Regulator/Hose assembly by yourself. It must be done by a

qualified licensed technician only.

FIG. 23 LP Gas

INSTALLATION

GAS HOOK-UP