DCN DCRS-9800 Series, Инструкция по установке

Страница: 61 / 63

DCRS-9800 InstallManual Chapter 2 Hardware Installation
2-21
2.6.4 Connecting to the Console
The DCRS-9800 provides a RS-232 port as the local console. Users can configure
the switch through a character terminal (usually a PC) with RS-232 ports. The connection
procedures are listed below:
Step 1: Find a character terminal or a PC with a RS-232 serial port.
Step 2: Connect the RS-232 serial port of character terminal to the configuration port of
the switch, ensuring at least one of them is powered down.
Upon connection, please verify the sign above the port to avoid using the wrong port.
2.6.5 Connecting to the Management Port
The main card provides a RJ-45 (female) Ethernet port. Users can connect to this
administration port through a backend host with Ethernet interface for program loading, or
use this port to connect to remote devices (e.g., an administrative workstation) for remote
administration. The connection procedure is listed below:
z Connecting to a back-end PC
Step 1: Find a PC with Ethernet Interface.
Step 2: Connect the PC to the RJ-45 Ethernet port of the switch with a twisted-pair
crossover cable.
z Remote Administration of the device
Step 1: Connect the administrative Ethernet port in the main controlling board to a
HUB with a standard network cable.
Step 2: Connect the Hub to an administrative workstation in the local area network.
Or:
Step 1: Connect the administrative Ethernet port in the main controlling board to a
Router with a crossover network cable.
Step 2: Connect the router to an administrative workstation in the wide area
network.
2.6.6 SFP transceiver installation
In the DCRS-9800, each line card with a 1000BASE fiber interface provides several
SFP 1000BASE transceiver slots.
Notice