PSXX Manual Rev: A Software Rev: F
9
times every foot. You can make your own twisted pair wire by placing two ends of the
wire in a drill bit, chuck the drill tight, and then turn on while you or something else
holds the other end
***
PSXX LED Outputs do not require resistors***
E. Terminal Wiring Descriptions
J1 Input Power Connector
●
J1-1 DCC Power Input 1 [from DCC Booster]
●
J1-2 DCC Power Input 2 [from DCC Booster]
●
J1-3 Connect to next PSXX J1-1 [Power Link]
●
J1-4 Connect to next PSXX J1-2 [Power Link]
J2 Output Power Connector
●
J2-1 Switched DCC Power Output 1 [to track/bus]
●
J2-2 DCC Power Output 2 [to track/bus]
JP1 Program Jumper
●
JP1-1 & JP1-2 Place jumper on pins 1 & 2 for Programming
●
JP1-2 & JP1-3 Place jumper on pins 2 & 3 for Operations
J4 Block Occupancy
●
J4-1 Input Manual OFF +
●
J4-2 GND Manual OFF -
●
J4-3 Output Block Shorted Emitter
●
J4-4 Output Block Shorted Collector
●
J4-5 Output Block Occupied Emitter
●
J4-6 Output Block Occupied Collector
J5 Status Outputs [Remote]
●
J5-1 +Remote D17 (RED) Anode
●
J5-2 - Remote D17 (RED) Cathode
●
J5-3 + Input Photocell
●
J5-4 - GND Photocell
J6 Trip Current Settings by Jumpers
●
Set trip current using either Jumpers or CV 49: NOT BOTH
●
No Jumpers = 2.0 amperes [default]
●
J6-1 to J6-2 = 1.0 amperes
●
J6-3 to J6-4 = 3.0 amperes
●
If both jumpers are installed [J61-J62 & J63-J64], the current limit is set to 4.0 amperes.
***
PSXX LED Outputs do not require resistors***
