PSXX Manual Rev: A Software Rev: F
22
For all systems, whenever you enter an address or CV value, you should see D6 flash. This indicates the
PSXX has received the information, stored it, and verified the stored data match the data you sent.
NCE Setting PSXX Addresses:
Using Pro Cab or Power Cab
1. Turn DCC Power off.
2. Move PSXX JP1 Jumper to Program Position Pins 1 & 2
3. Turn DCC Power on.
4. Press SELECT ACCY.
5. Enter the new switch number using the numerical keypad.
6. Press ENTER
7. Press either 1 or 2 to set the address.
8. Repeat steps 4 thru 6 until all of the switch addresses are set.
9. Turn DCC Power off.
10. Move PSXX JP1 Jumper to Run position Pins 2 & 3
11. Turn DCC Power on.
12. Test the switch setting using the SELECT ACCY key.
NCE Programming PSXX CV’s:
NCE Pro Cab or Power Cab
1. Turn DCC Power off.
2. Move PSXX JP1 Jumper to Program Position Pins 1 & 2
3. Turn DCC Power on.
4. Use SELECT LOCO to address an unused locomotive number.
5. Press PROG/ESC key to enter PROGRAM ON MAIN mode.
6. Press ENTER to select any unused locomotive number
7. Press ENTER again.
8. Press 2 to enter PROG CV NUM.
9. Enter CV number
10. Press ENTER.
11. Enter value to be stored
12. Press ENTER.
13. Repeat steps 8 and 9 until finished.
14. Press PROG/ESC to return to normal operation.
15. Turn power off
16. Move PSXX JP1 Jumper to Run position Pins 2 & 3
17. Turn power on.
18. Test the PSXX using the SELECT ACCY key.
Audible Short Indication
The two holes inside the circle [U8] on the top of the board are for use
with an audible short indicating device. It is designed for use with part no. compsonalert. The device
is installed with the [+] terminal in the square hole.
You can obtain these components for all PSXX devices from
Tony’s Train Exchange: 800.978.3472 [email protected]
Part no. compsonalert Part no. screwtermkitpsxx1 Part no. dsppsxx.pb
Audio Alert Screw Terminal Kit for PSXX Reset Push Button Switch
