15
NOTE
Several commands allow port numbers or port number
ranges to be included on the command line. When port
numbers are included, the syntax is as follows:
(Command)1
Port 1
(Command)1,2,6
Ports 1, 2 & 6
(Command)1 2 6
Ports 1, 2 & 6
(Command)2-6
Ports 2 thru 6
(Command)1,5-8
Ports 1 and 5 thru 8
5.4.3
Change Port Config
The Change Port Config (CP) command sets the local port loopback, flow
control and rate configuration. One or more ports may be set with a
single command by selecting a range of port numbers. The factory
default setting is Xon/Xoff Space, 9600 bps.
5.4.4
Remote Change Port Config
The Remote Change Port Config (RCP) command sets the remote port
configuration. This command requires a
local
(Host) port number
argument. The host multiplexer sends the configuration to the proper
remote drop and port number based on the system map. One or more
ports may be set with a single command by selecting a range of port
numbers. The syntax is the same as the CP command.
5.4.5
Show ID
The Show ID (SI) command is used to view either multiplexer or port
identifiers. If (M)ux is selected, both host and drop multiplexer IDs are
displayed. If (P)ort is selected, both host and drop port IDs are
displayed.
5.4.6
Change ID
The Change ID (ID) command allows you to set or change both host and
drop multiplexer or port identifiers. Port IDs are entered in pairs
referenced to the host port number. Pressing <Enter> with no entry
will leave the ID unchanged.
