dbx ProVocal, Руководство пользователя

Страница: 18 / 33

Basic Operation
10
Section 2
ProVocal ™
output connections, use either XLR or 1/4” Line output.
• Apply power to the ProVocal™. Connect the AC power cord to the AC power receptacle on
the back of the unit. Route the AC power cord to a convenient power outlet away from audio
lines. The unit may be turned on and off from the front panel power switch or from a mas-
ter equipment power switch.
• After all connections have been made, make the appropriate front panel line settings i.e.: Line
switch, 48Volt switch (and/or 20dB Pad), and adjust the Gain adjustment until the signal LED
lights, with the clip LED only lighting occasionally.
Program Operation/Edit Mode
After all connections have been made, you are ready to use the ProVocal™. The following
information will provide you with basic guidelines to get the most out of your unit.
•
Program Scrolling
- To scroll through any one of the 40 Factory and 40 User programs, use
the <Program> up and down buttons. User Program are numbered 1-
40, and Factory Programs are numbered 41-80.
•
Program Editing -
Once a program has been selected, you can fine-tune the program to your
requirements, and then save it as a User program by using the following procedure.
• To access a selected effect module block, simply press the <Effect> button until the
desired module with the corresponding LED in the effect matrix has been reached.
Successive presses of the
<Effect> button will scroll through the effect matrix.
• Once the effect module to edit has been reached, use any of the five parameter
knobs to edit the parameter of the corresponding effect indicated in the effect
matrix. The display window will show the parameter value in real time.
Note that the parameter knob LED will light once the parameter’s stored
value has been reached.
• Once all of your changes have been made to the current program, you can now
save this custom program into the User bank of Programs. To save your changes,
press the
<Store> button and then use the <Program Up> or <Program Down>
buttons to select the desired user Program number. Once the desired number has
been reached press the
<Store> button again.
3 ProVocal™ User Manual
386 User Manual