DB Audio DS10, Руководство пользователя

Страница: 10 / 22

3.4. Front panel
3.4.1. BYPASS/NETWORK
BYPASS/NETWORK switch
The BYPASS/NETWORK switch allows the use of the DS10 as an
AES3 distribution amplifier. When set to “BYPASS” the digital
inputs are routed (with negligible latency) to all outputs. That
means Inputs 1-4 are routed simultaneously to outputs 1-4, 5-8,
9-12 and 13-16 as shown in the graphic opposite.
In “BYPASS” mode, the network switch is still fully operative (for
example for use in control traffic), and the DS10 is shown in Dante
Controller. However, no Dante routing is allowed from or into the
device, and the device does not participate in the Dante master
clock algorithm (i.e., it cannot act as Clock Master). The Network
Switch Mode can still be configured from Dante Controller, and
the corresponding port modes will be shown by the port LEDs.
When the switch is set to “NETWORK”, the DS10 operates as a
normal Dante device.
The bypass switch can be operated while the device is working.
When switching from “NETWORK” to “BYPASS”, the output
channels are routed from the DS10 digital inputs as described
above, and all devices on the Dante network that were receiving
audio from the DS10 stop receiving immediately. When switching
from “BYPASS” to “NETWORK”, these devices start receiving the
audio from DS10 again, and the "RX Subscriptions" in the DS10
that were in place before switching to “BYPASS” are restored.
Note: When the DS10 is powered off while in bypass mode,
the "RX Subscriptions" will not be re-established (all RX
channels will be un-subscribed instead).
3.4.2. DIGITAL OUT 1 – 4
Two digital output connectors (OUT 1/2 and OUT 3/4) are
provided and are intended to feed the AES signal to the inputs
D1/2 and D3/4 of the I/O panel within a d&b Touring rack
assembly.
3.4.3. DIGITAL IN 1 – 4
In addition, two digital input connectors (IN 1/2 and IN 3/4) are
provided to allow the signal bridge to act as a break-in box with a
maximum of four AES3 input channels per signal bridge.
Note: Sample Rate Converters (SRC) are used internally on
both inputs.
BYPASS/NETWORK switch
Bypass routing
d&b DS10 Manual 1.5 en 10