7
10. Repeat steps 7 to 9 with the remainder of the mounts on this side.
11. After you have installed on one side remove the 4x6 jacking block and lower
down the Jeep tub onto the body mounts and install the 2 nuts and 1 bolt per
mount and had tighten down and move the floor jack over to the other side
and repeat steps 5 threw 10. If all the mounts have been installed, remove the
4x6 jacking block and lower jeep tub onto the body mounts
.
12. With all the body mount spacers installed remove the floor jack. use a 16mm
socket and tighten all the 2 nuts per mount down to 40 ft lbs. Using a 18mm
socket tighten down the 1 bolt per mount down to 80ft lbs.
13. Connect the electrical connectors(4) and position the grill(2) onto the front
end of the grill support and seat the clips(3) fully. Install the push pin fasten-
ers(1).
