DAYLIFF B25, Инструкция по установке и эксплуатации

Страница: 17 / 36

14
Adjustment of blade inclination
Ÿ
Turn the engine off and wait for the blade to stop.
Ÿ
Loosen the knob (1) and incline the cutting device (2) as desired, see picture 3.
Ÿ
Tighten the knob (1) securely. If the knob does not move enough to guarantee it is
tight, extract it and re-position it so that it can be tightened securely
WARNING
Do not work unless the cutting device is locked securely
Ÿ Proceed to cut by using curved movements from the bottom towards the top, keeping
the blade as far from the body as possible.
VERTICAL TRIMMING
HEDGING HEAD
Before starting work check the following:
Ÿ All the screws on the machine and the blade are tightly fastened
Ÿ Blades are sharp and there are no signs of any damage
Ÿ Protection devices are well fastened and working efficiently
Ÿ Handgrips are well fastened
Ÿ Cut branches up to a maximum diameter of 4.5mm; cutting branches with a larger
diameter may damage the trimmer.
Ÿ ONLY adjust the tilt angle with the motor switched off. SWITCH OFF the motor
before removing any branches caught up in the blades.
Ÿ Never bring the blades close to body parts while working.
Ÿ Always fit the blade guards when the device is switched off
Direction of use
1
2