5
GB
If you cannot � x the problem, the gas heater
must not be used!
Close the regulator after the leak test.
If there are still leaks, contact your dealer
immediately. DO NOT use the gas heater if
there are leaks!
Do not use a naked � ame to search for leaks.
Smoking and use of naked � ames are strictly
forbidden when testing for leaks!
Positioning
Position the gas heater so that it faces into
the centre of the room at a safe distance from
walls and in� ammable materials.
Place the gas heater on a � at, stable
surface. DO NOT place the gas heater on
rugs, carpets, in front of mains sockets,
near bed linen and curtains, or on tables or
countertops.
Igniting the gas heater
Open the regulator on the gas cylinder.
On the control panel for gas operation (1),
turn the power selector to position
and
press down for about 10 seconds.
Press the IGNITION button a few times while
holding in the power selector until the pilot
� ame in the burner lights.
Hold the power selector down for around 15
seconds and then turn to the desired setting.
CAUTION: Do not turn the power selector
hard. The button must be pressed down
before the heat setting is changed. The
power selector cannot be turned until it has
been pressed in. Make sure that the button is
locked in the required heat setting/position.
1 / LOW: The lowest heat setting
2
/ MEDIUM: The middle heat setting
3
/ HIGH: The highest heat setting
Note! The gas heater must run on the lowest
heat setting for 3 minutes before you turn it
to a higher heat setting!
Do not press the ignition button for more
than 40 seconds.
Ignition button
Power selector