DAXOM UKDAX-20BT, Инструкция по установке и эксплуатации

Страница: 29 / 45

29
Drill screw holes according to hole of mounting template that is supplied with
water heater and then drive pins. Fasten mounting template to the wall by
using
Ø10 mm diameter screws. If it is needed, take additional precautions for
durable fasten of mounting template to the wall.
According to pipe dimensions which is given below figure drill pipe hole which
is 100 mm (For UKDAX 20 BT) or 2 pcs pipe hole which is 100 mm (For
UKDAX -33 BT).
Install water heater on the durable fasten mounting template as install up to
down. Be sure heater is installed to the mounting plate completely.
Pipe must be used which is suitable for condensing water heaters.
Place the fresh air/waste gas pipe into the holes previously opened for the
exhaust as their clearance will stay outside. Mount the relevant edge of the
bracket part to the water heater flue and mount the other edge as to pass over
the waste gas pipe.
The edge part of waste gas pipe must be place to the up with inclines as it
makes 3 degree horizontal angle.
4.2. The Wall Mounting Of The Heater
4.2.1. Mountaning Of The Waste Gas Pipe