DAXOM UKDAX-20BT, Инструкция по установке и эксплуатации

Страница: 40 / 45

40
through the unit and the temperature should
increase.
Water is cols when single
tap is open
If the water flow is less than 3lt/min, heater
will not heat the water. Open tap more or open
another tap. Water temperature will be higher
Hot Water Temperature
Changing
Clean the water filter.
HOT WATER AMOUNT
Flow Hot Water Not
Constant
If it is supplied hot water from another taps,
flow rate can be decrease.
Decreasing or increasing water pressure at
plumbing and another plumbing
problems can cause changings at
temperature of water and flow rate of the water.
. At the beginning taps can be drain high
volume hot water but then equilibrate.
For stabilize of temperature reduction ,
heater limits the water amount by flowing less
amount water but then it increases.
Hot water amount is less or
much
It is because of using hot water more than
one tap at the same time.
Water amount is getting
less eventually
Is there blocking at water drain valve?
REMOTE CONTROL
POWER BUTTON LIGHT
NOT ON
Is there power error?
Is power connection being made correctly?
Control all electrical connections and remote
control connections.
Control fuse
Control position of ON/OFF button.
OTHERS
Ignition stop while heater is
operating.
Are gas and cold water valve open?
Is there cold water flow at heater?
Is hot water tap is open?
Is enough gas coming to heater?
Is there’re enough gas in tank? (For LPG
use)
White smoke comes out
from exhaust vent.
This is normal, the white smoke is actually
water vapour condensing out of the flue gas.
The hot water has ait
bubbles
This is normal. Small air bubles apperar as
the water is heated and depressurized rapidly
to atmospheric peressure.
Water Leakage from drain
tap
If the heater is under high water pressure
(Over 10 Bar) for safety water leakage from
pressure reduce valve so that heater not
damage by the high water temperature.