DAXOM UKDAX-20BT, Инструкция по установке и эксплуатации

Страница: 23 / 45

23
Thanks to its feature of digital constant water setting, the water temperature
will remain constant in the degree you set.
The fuel efficiency is reduced in low water temperature as your device can
operate in the desired constant water temperatures.
By the automatic water controlled on/off system, when the water valve is
opened, the water heater will be ignite automatically and the hot water flow
will be provided. When the water valve is closed, the water flow will stop and
the flame will be off automatically.
Thanks to its feature of operating with low pressure water, it will not be
affected by the low water pressure that occurs in the high apartment flats. 2
mSS
The temperature control adjustment buttons make for users easy to obtain
different water temperature that they desire.
By the high pressure safety system, when the water pressure is higher than
it’s needed, safety valve will discharge the excess water by become a part of
a activity.
By the high temperature safety system, in case of the water getting hotter
than it is needed, the gas will be cut off automatically and the damage of the
water heater will be prevented.
The flame instability is prevented and the water is cooled after the flame is off
with the features of blowing inside the water heater before the ignition (air fan
blows air for 2~4 seconds before ignition) and the blowing after service (air
fan will go on blowing air for 10 seconds after the water stops and the flame is
off).
Thanks to the safe and reliable design of the combustion system, the air is
taken from outside by the fan for the purpose of the combustion and it is sent
out again after the combustion.
By the system of continuous electronic ignition, 100% success is achieved in
ignition.
The device is equipped with the multi-purpose safety system. Even if the
power is supplied to the water heater again in power failure, fan failure, the
blocking of the waste gas pipe or strong reverse wind blowing the gas will be
automatically cut and the automatic ignition system will be disabled. In this
case the water heater will need to be restarted.
1. THE FEATURES AND THE CHARACTERISTICS OF YOUR
WATER HEATER