PAGE 1
PAGE 4
#1482
STANDARD
LAUNCHING WHEELS
This product is not designed to be used on loads over 220 lbs. (100 kg).
In most cases, you can operate the
craft without removing the wheels.
CAUTION: This product
is not designed to be
towed behind a vehicle.
Damage may occur and
will void the warranty.
INSTALLED ON ALUMINUM BOAT
INSTALLED ON HARD TRANSOM
INFLATABLE BOAT
Detent Pin
WHEEL UP WHEEL DOWN WHEEL REMOVED
CARRYING THE BOAT
Wheel-a-Weigh transom wheels are portable and removable.
A detent pin on each pivot bracket lets you position the
wheels up or down, or remove them completely for storage.
Tape Measure
Removable Tape
Square
Drill with
3/16” (5 mm) Bit
Phillips Head Screwdriver
Sealant
Pencil or Marking Pen
8 mm Hex Wrench or
Crescent Wrench
TOOLS NEEDED FOR INSTALLATION
ONE-YEAR WARRANTY
We warrant our products to be free of defects in material
and workmanship for one year from the date of original pur-
chase. Write for full warranty details.
This warranty does not apply to product which has been
used on loads weighing more than 220 pounds (100 kg).
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
For information about our other fine products,
visit www.davisnet.com
01482.010 July 2016
8.
AFFIX PIVOT BRACKET. 3/16" (5 mm) machine
screws and hex nuts are provided in the parts kit, as
are a nylon spacer and backing plates for inside the
transom. Apply sealant behind spacer. Assemble
parts as shown below.
9.
ATTACH WHEELS. With both pivot brackets installed,
the wheel frames can now be fastened with the
detent pins.
Machine
Screws
Pivot
Bracket
Nylon
Spacer Sealant
Backing
Plates
Hex Nuts
Detent Pin
(8 mm,
Stainless Steel)
7.
DRILL FOUR 3/16" (5 mm) HOLES through the tran-
som for attaching the pivot bracket.
