SONIC-ANEMO-DZP
© LCJ Capteurs 2016 – All rights reserved.
Page 5
On a pole:
Pole diameter: Ø 35 min ; Ø 48 max.
On a vertical surface:
(the sleeper screws are not supplied)
Stop
Max. tightening torque: 1.5 N.m
Ø 6 max
4.
Wiring
The SONIC-ANEMO-DZP includes a data cable with a RJ11
connector to connect to the VP2 Interface and 2 pairs of wires
with connectors for the battery connection.
5.
Power supply
The PV panel ensures the SONIC-ANEMO-DZP operates
independently.
The energy is stored in a LiFePO4 battery of 3.2 V – 600 fitted in a
14500 box.
6.
Connection to the ISS Davis VP2
Follow the following instructions to connect the SONIC-
ANEMO-DZP to a ISS Davis VP2 :
a)- Open the SIM box, sliding the cover upwards.
b)- Disconnect the Solar Module if it is fitted.
Photos credit DAVIS Instruments.
4. Configuration of the DAVIS VP2
The anemometer cups must be set to "OTHER" in the Setup Menu.
c)- Take out the cap to insert the SONIC-ANEMO-DZP's RJ11.
d)- Connect on the "WIND" socket.
b)- Connect the Solar Module back if required.
f)- Put the cap and the cover back in place.
Note: Refer to your DAVIS VP2 for more information about the Interface Module.