11
Data Screens
Note: Driver ID code 0000 (four zeros) is used to view information for the vehicle
(all drivers) and should not be assigned to any driver.
In addition to marking data as belonging to a particular driver, the
Driver ID code may be used on the device to filter the information
being viewed. To view information for one specific driver, enter that
Driver’s ID code in this screen. The DriveRight 600
E
display filters out
any data not assigned to that code. To view all information, regardless
of Driver ID Code, enter 0000.
The following options are available in the Driver ID Code Entry
Screen:
• Enter a Driver ID Code —
When the Driver ID Code Entry Screen
is first displayed, the first digit to the left flashes, indicating that it is
the active digit. Press and release PLUS or MINUS to cycle forward
or backward through the available entries for the active digit (0 to 9).
To change the digit which is active, press and release SET/CLEAR.
The digits are cycled through each time SET/CLEAR is pressed.
Only the Driver ID codes that have been programmed into the
DriveRight 600
E
are accepted. A “NO” displays on the screen if a
wrong ID code is entered. A code of “0000” is still accepted.
• Log Out —
Press and hold SET/CLEAR for 2 seconds, until the
code resets to 0000. As soon as a driver logs out, the current trip is
ended and data for that trip is stored in the DriveRight 600
E
’s
memory. Do not log out when the vehicle is in motion.
Two Digital Inputs
Two digital inputs are available on the DriveRight 600
E
that track the
operation of lights or other electrically powered accessories on the
vehicle. A typical application would be to monitor the headlights and
the brakes. The screen displays “1” if the input is high, and “0” if the
input is low. The status of the inputs is stored in the trip log.
Activity Indicator
Primarily useful for troubleshooting the installation, the small “dot”
between the two activity indicators displays whenever the reed switch
used with the General Duty (# 8126GD) and Heavy Duty (# 8126HD)
models is closed, or whenever the VSS input used with the VSS (#
8126VSS) model is high. The reed switch closes once each time the
vehicle’s drive shaft rotates.
Trip Start/End Log Screen
The Trip Start/End Log Screen shows the start and end time for each
trip currently stored in the DriveRight 600
E
’s memory. To view trip
times for a specific driver, enter that driver’s ID code in the Driver ID
