DAVIS 6832, Руководство пользователя, Страница: 9 / 12

7
7. Remove the white junction board cover and unplug the fan power cable from the
junction board.
8. Lift out the fan and the fan deflector.
9. Pull the temperature/humidity sensor up and
out.
10.Use a soft brush to clean the white plastic and
gold mesh of the sensor.
11.Remove all debris from inside the shield and
fan and wipe the interior surfaces with a damp
cloth.
12.Remove the screen from the bottom of the
radiation shield. Wipe it clean, as well as up into
the interior of the radiation shield. Replace the
screen.
13.Replace the temperature/humidity sensor. It fits
one way, into the slots on the side. Route the
cable up through the channel and replace the fan
deflector with the cable channels correctly
aligned with the sensor cable. If a new fan and
batteries are needed, See “Replacing the Fan
Motor and Batteries” on page 8.
14.Replace the fan and plug the fan power cable
back into the junction board. The fan should
start to rotate.
Fan Unit
Fan Deflector
Temp/Hum
Sensor Cable
Channel
Temp/Hum
Sensor Cable
Fan Unit
Fan Power
Cable
Junction Board
Cover (removed)
Junction Board
Temperature/
Humidity
Sensor