DAVIS TECHNOLOGIES TMS-9500-SL Short, Руководство пользователя

Страница: 13 / 36

13
Davis Technologies TMS-9500-SL Short
www.moretraction.com
Traction Control Setup
The following parameters are adjustable; however
they are factory set to the most common settings, and
should not need to be adjusted by most users.
(These settings are only accessible using the
“Traction Control Panel Software” or Handheld
Programmer)
Trigger Count:
The unit is factory set for 4 triggers per revolution, for
8 cylinder operation. The unit can be configured to
use between 1
–
9 triggers per revolution.
Starting RPM
is a user adjustable setting that
allows the racer to set the point at which the unit
begins making corrections. If the Starting RPM is set
to 5000 RPM, then the unit is active and monitoring
the engine, but not making any corrections until the
Starting RPM is reached. Once the Starting RPM is
reached, the unit will make corrections as needed
above 2000 RPM.
Buffer
is another setting that can be used to fine
tune the system. The buffer sets the number of
consecutive errors required to cause a correction.
Buffer 0 will react to each error in acceleration. Buffer
1 will require at least 2 consecutive slip conditions to
cause a correction. This is useful to filter out small
tire slips that may occur quickly, but have no ill effect
on the car.
(Default=1)
Sample Rate
of the unit can also be changed by
the user, however this should only be done after
consulting w/ tech support. The lower the number the
faster the Sample Rate, which makes the unit less
sensitive, but faster to react. The higher the number
the slower the Sample Rate, which makes the unit