Davis Instruments GroWeather, Руководство пользователя

Страница: 60 / 65

Display Scan
GroWeather Manual Page 53
D
ISPLAY
S
CAN
The GroWeather comes with two pre-programmed scan routines which contin-
uously cycle through various displays. The short scan routine displays the cur-
rent value of every condition measured or calculated by the GroWeather. The
long scan routine displays the current value of every condition measured or
calculated and every high/low stored by the GroWeather. The long scan rou-
tine does not show the times at which highs/lows were recorded.
Starting the Scan Routines
1. To start the short scan routine, press SCAN.
The unit begins to cycle through the short scan routine. Until you stop the
scan routine, it will continuously cycle through every condition measured or
calculated by the GroWeather.
2. To start the long scan routine, press SCAN again.
The unit begins to cycle through the long scan routine. Until you stop the
scan routine, it will continuously cycle through every condition measured or
calculated by the GroWeather and every high/low value stored by the
GroWeather.
Stopping a Scan Routine
A scan routine will continue until you manually stop it or until an alarm is trig-
gered. To stop a scan routine, simply press any function key. The unit will stop
the scan routine and display the appropriate condition.
C
ALIBRATION
N
UMBERS
Calibration numbers exist for many conditions and enable you to adjust the
displayed value to your satisfaction. This section explains calibration numbers
and how to set or change them.
Inside and Outside Temperature
You may use temperature CAl to adjust the temperature up or down a specific
number of degrees. Note that there are individual CAL numbers for both tem-
perature readings. If you change CAL for temperature, any calculated data
which uses temperature (wind chill, for example) will also be affected.
Calibrated Temperature = Tempe CAL
Default CAL = 0 (for ˚ F and ˚C).
Humidity
You may use humidity CAl to adjust the humidity up or down a specific num-
ber of percentage points. If you change CAL for humidity, any calculated data
which uses humidity (T-H index, for example) will also be affected.
Calibrated Humidity = Hu CAL
Default CAL = 0%.