Tools and Materials Needed
Page 3
T
OOLS
AND
M
ATERIALS
N
EEDED
In addition to the components listed on page 2, you may need some of the fol-
lowing tools and materials.
✦
Flat-Bladed Screwdriver
✦
Phillips Screwdriver
✦
Adjustable Wrench
✦
Wire Cutter or Scissors
✦
Wire Stripper or Knife (Industrial Installation Only)
✦
Electrical Tape
✦
Cable Clips or Weather-Resistant Cable Ties (with ability to be mounted)
✦
Hammer
I
NSTALLATION
S
TEPS
This manual takes you through the step-by-step process of installing your
weather station. These steps are indicated below, along with their page num-
bers for easy reference:
✦
Assemble and test the station, page 4
✦
Detach the extension tube, page 4
✦
Attach the anemometer, page 4
✦
Attach the wind cups, page 4
✦
Snip the cable tie in the rain collector, page 5
✦
Apply power to the console, page 5
✦
Attach the EZ-Sensor Arm, page 6
✦
Connect sensor array to console, page 8
✦
Check that the console and sensors are working properly, page 8
✦
Re-attach rain collector cone and unplug sensor array
(or ICAM)
cable from console, page 8
✦
Install the station, page 9
✦
Choose locations for the sensor array and console, page 9
✦
Mount, secure, and ground the sensor array, pages 10 & 11
✦
Run sensor array cable
(or ICAM cable)
to console, page 11
✦
Industrial stations only
: mount the ICAM, page 11
✦
Mount the console, page 14
If, once installed, you encounter any problems with the station, please refer to
the troubleshooting guide on page 14 or call our technical support line (510-
732-7814) for assistance.
