9
Mounting Transmitter Shelter on a Pole
1. While holding the
shelter against the
pole, place a U-bolt
around the pole and
through the two
holes on at the top of
the shelter.
Flat
Washer
Lock
Washer
Hex
Nut
U-Bolt
2. Place a flat washer, a
lock washer and a
hex nut on each of
the bolt ends.
3. Using an adjustable
wrench or 7/16"
wrench, tighten the
nuts.
4. Place the second U-bolt around the pole and through the two holes at the bottom of
the shelter. Put a flat washer, a lock washer, and a hex nut on each bolt end, and
tighten the hex nuts.
Note:
Remember to position the shelter so the solar panel has maximum exposure to the sun.
Mounting Transmitter Shelter on a Vertical Surface
1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a
carpenter’s level to ensure the holes will be level.
2. Drill two more holes 7-
1/32" below the upper
holes.
Flat
Washer
Lag
Screw
3. Insert the 1/4" x 1-1/2"
lag screws through the
flat washers, and through
the holes at the top of the
shelter into the post.
Using an adjustable
wrench or 7/16" wrench,
tighten the lag screws.
4. Insert the 1/4" x 1-1/2"
lag screws through the
flat washers, and through
the holes at the bottom of the shelter into the post. Using an adjustable wrench or
7/16" wrench, tighten the lag screws.
Note:
Remember to position the shelter so the solar panel has maximum exposure to the sun.
