8
3. Swivel the
anemometer until
the arm is pointing
north, if possible.
U-Bolt
1/4" Flat Washer
1/4" Lock Washer
1/4" Hex Nut
4. Using an
adjustable wrench
or 7/16" wrench,
tighten the nuts. If
the anemometer
arm is not pointing
north, calibrate
your console by
following the
instructions in your
console manual.
Mounting Anemometer on a Vertical Surface
1. With a 3/16" (5 mm) drill
bit, drill two holes
approximately 2-1/8" (54
mm) apart. Use a
carpenter’s level to
ensure the holes will be
level.
1/4" Flat Washers
1/4" x 3" Lag Screws
40' of Anemometer Cable
2. Insert the 1/4" x 3" lag
screws through the flat
washers and the holes in
the mounting base into
the post.
3. Using an adjustable
wrench or 7/16" wrench,
tighten the lag screws. If
the anemometer arm is
not pointing north,
calibrate your console by
following the instructions
in your console manual.
