Davies Craig 0500, Руководство по установке

Страница: 2 / 8

19/12/2018 DIGITAL GAUGE THERMATIC

FAN/EWP

SWITCH 2 | P a g e
DIGITAL GAUGE THERMATIC
®
FAN/EWP
®
SWITCH MOUNTING
The Digital Gauge Thermatic
®
Fan/ EWP
®
Switch is compatible with many 52mm
Gauge stands and mounts.
The Digital Gauge Thermatic
®
Fan/ EWP
®
Switch MUST be mounted inside the
passenger compartment to minimise its ambient temperature and exposure to
water.

For a neat installation the Gauge Display can be mounted to the underside of
the dash to avoid drilling holes in the dash or having exposed wiring.
Locate or drill a minimum 13mm hole in the dash and pass the wiring loom
through leaving the ‘loom connector’ free to plug into the Gauge.

Thermal Sensor wire MUST NOT be cut in ANY circumstances.

Ensure the mounting location allows easy access to the 3 set buttons.

If using an alternative mounting method follow appropriate installation
procedure.
Mount the Gauge Stand in position. This can be done using the two screw holes in
the base of the stand or with the double-sided tape disc.
Pass the ‘loom connector’ through the rectangular hole in the back of the Gauge
Stand and plug into the socket of the Gauge.
Carefully push the Gauge Display into the Gauge Stand ensuring the rubber
retainer ring is installed on the Gauge Display.

Be mindful of the orientation of Gauge Display as it can be hard to rotate once
fully installed into the Gauge Stand.
DIGITAL GAUGE THERMATIC
®
FAN/EWP
®
SWITCH WIRING
Ensure all wiring is protected from rubbing on bare metal or other sharp edges.
Locate a hole in the firewall (approx.15 mm in diameter) and pass the required
wiring (below) through the firewall from the passenger cabin to the engine bay.

BLUE “FAN 1” wire.

ORANGE “FAN 2” wire.

Temperature probe wiring.

GREEN “AIR CONDITONER” wire (OPTIONAL).
If using the “AIR CONDITONER” wire as a manual override simply
connect it to a positive source though toggle switch.
Locate a Positive ignition or accessories source within the passenger compartment
and connect the RED “IGNITION” wire.
Connect the BLACK “EARTH” wire to the chassis or negative Earth supply.
If using the Dimmer function locate a positive source that is controlled by the
headlight switch and connect the “DIMMER” wire. YELLOW

If an appropriate source cannot be located you will need to run the YELLOW
“DIMMER” wire through the firewall and connect it to the positive feed of one
of the headlights.
*For positive earth systems, wire ‘Earth’ to battery negative not the chassis