Davey WHISPER Series, Руководство по эксплуатации

Страница: 7 / 8

7
A
B
D
E
G
C
F
G
DIMENSIONS
Model
Q
max.
(l/min)
H
max.
(m)
A 1 ~
230V
C –
µF
P1
(kW)
IP
Eff.
(%)
dBa
± 1
A
(mm)
B
(mm)
C
(mm)
D
(mm)
E
(mm)
F
(mm)
G
(mm)
kg
Whisper 500W 180 12.2 2 12 0.45 55 35 <70 475 115 301 108 212 312 Ø48 7.4
Whisper 750W 230 13.5 2.9 12 0.65 55 42 <70 475 115 301 108 212 312 Ø48 7.7
Whisper 1000W 290 14 3.8 12 0.85 55 50 <70 475 115 301 108 212 312 Ø48 8.5
Typhoon C75M 340 15 5.5 16 1.2 55 47 <70 532 170 345 159 238 330 Ø48 10.7
Typhoon C100M 380 16.5 6.2 16 1.5 55 48 <70 532 170 345 159 238 330 Ø48 11.4
Typhoon C150M 430 18.5 7.1 25 1.6 55 55 <80 560 170 345 159 238 330 Ø48 13.5
Typhoon T150M 500 19 8.5 25 1.9 55 61 71 613 200 397 231 429 270 Ø63 18
Typhoon T200M 550 19.5 9.7 30 2.2 55 64 72 613 200 397 231 429 270 Ø63 20.7
Typhoon T300M 650 22.5 12.5 60 2.6 55 63 73 613 200 397 231 429 270 Ø63 20.6
V/Hz esp.: See pump nameplate Liquid Temperature: 4°C ~ 35°C Storage temperature: -10°C~ +50°C Relative Air Humidity: 95% Max. Motor class: I
H max. refers to the maximum total head in metres.
Possible faults, their causes and solutions
1. Pump does not prime 2. Pump supplies scant flow 3. Pump noisy
4. Pump does not start 5. Motor makes sound but does not start
1 2 3 4 5 Problem Solution
X X Air entry through suction line Verify condition of connectors and gaskets of suction linw
X Inadequate airtightness of filter cover Clean the filter cover and verify condition of rubber gasket
X X Motor turning direction reversed Reverse 2 phases of the supply
X Defective mechanical seal Change mechanical seal
X X Excessive suction height Set pump at a suitable level
X X X Incorrect voltage Verify the voltage specified on the nameplate and that of the mains
X No water in prefilter Fill prefilter with water
X Suctioning out of water Set suction in correct position
X Filter clogged Clean filter
X X Diameter of suction line smaller than required Correctly dimension suction line
X Discharge clogged Inspect filter and discharge line
X Incorrect pump attached Attach pump correctly
X Foreign body in pump Clean pump and inspect its filter
X Thermal relay tripped Reset thermal relay
X Lack of power Reset the fuses
X Motor blocked Remove the motor and call the technical service
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard.