8
INSTALLATION INSTRUCTIONS
Things you should be aware of:
• Before installing RainBank please
read all instructions carefully as
failures caused by incorrect
installation are not covered under
warranty.
• The pumping of abrasive materials
will damage the system and void the
warranty.
• Some insects such as small ants find
electrical devices attractive for
various reasons. If your controller or
pump is susceptible to insect
infestation you should implement a
suitable pest control plan.
•
Limit mains water pressure to
600kPa.
• All pipe work and fittings should be
labelled in accordance with local
standards such as Australian
Standard AS/NZS 3500. This standard
requires that all pipework containing
rainwater is marked with green
‘rainwater’ tape or stickers at 1
meter intervals and every outlet that
may deliver rainwater is to be
permanently signed with ‘Rain Water’
signage or a green tap marked ‘RW’.
• Mains electrical connections and
checks must be made by a qualified
electrician and comply with applicable
local standards. The 12 volt
connections need not be carried out
by a qualified electrician, but should
be done in compliance with applicable
standards.
• In accordance with AS/NZS
60335.2.41 we are obliged to inform
you that this controller and any pump
controlled by it is not to be used by
children or infirm persons and must
not be used as a toy by children.
• Davey recommends a 2mm hole in
the pipe work just above the pump
outlet to clear air from the pipe work.
NOTE: Please be advised that a
disconnection incorporated in
the fixed wiring is to be provided.