17
Dimensions
A
C
E
F
G
H
I
D
B
A
B
C
D
E
F
G
H
I
Mounting
Holes
Diameter
Inlet/Outlet
PVC
Net
Weight
(kg)
305mm
670mm
320mm
350mm
65mm
230mm
380mm
200mm
250mm
10mm
40/50mm
14
9. USING YOUR PROMASTER WITH A SALT WATER CHLORINATOR
Chlorinators require a minimum flow rate through the chlorinator cell for best efficiency and cell life. Please
refer to your chlorinator guide as a reference for the flow required by your pool system. Ensure flow rate is
enough to cover your chlorinator cell plates completely at all times of operation.
10. OPERATING YOUR SUCTION POOL CLEANER
Before installing or purchasing a pool cleaner for use with your ProMaster, it is important to know the
minimum flow rates required for it to operate effectively.
To operate a suction pool cleaner:
• Activate the High Flow setting (10) and allow the pump to fully prime by running for around 2 minutes. You
will know the pump is primed when you can see a strong flow of water through the clear leaf basket lid.
• When all air is expelled from the leaf basket, connect the pool cleaner hose firmly into the skimmer plate or
dedicated wall suction.
• Select the speed setting that enables best performance from your suction pool cleaner. Speed 3 to 7 should
be ample for most cleaners, however if the cleaner requires better performance, select speeds 7 to 10.
• The cleaner should only be connected for as long as is required to clean the surface of your pool. When
cleaning is complete, disconnect the cleaner and remove the skimmer plate from the skimmer box.
• Reactivate the most efficient speed setting for daily filtration. Speeds 1 to 4 is recommended.
NOTE: To get optimum energy efficiency from your ProMaster, DO NOT keep the suction
pool cleaner connected when cleaning is not required.
NOTE: If the ProMaster is hard-wired into a time clock, or another automatic control, the
wiring should be removed by a qualified technician.
• Close the water valves on the pool return and the ProMaster inlet pipework;
• Remove the discharge & suction barrel unions taking care not to lose the o-rings;
• Move the pipework with the barrel unions attached until the ProMaster can be pulled clear.
NOTE: When making any enquiries about your ProMaster be certain to quote the model
number from the nameplate located on the motor.
