Step 3: CONNECTING THE PURIFIER
•
The Purifier has white packing tube inserted to protect it, remove the
packing tube by holding down the round collet at each end of the purifier
and pull out the tubing. Do not damage the collet or the internal fittings
of the purifier as any damage may make them leak or blow out once
water pressure enters the purifier.
•
Attach the purifier either vertically or horizontally to the back wall of
the cupboard using the brackets and screws supplied. Make sure the
inlet end of the purifier (refer to the label of the purifier bar code end) is
positioned nearest to the Pipe tap (or C-Clamp) you have just fitted.
•
Attach the Pressure Limiting Valve to the back wall of the cupboard
(either vertically or horizontally) in between the Pipe tap (or C-Clamp) and
the purifier, use the mounting bracket supplied with the pressure limiting
valve. Make sure the inlet of the Pressure Limiting Valve is aligned to the
Pipe tap (or C-Clamp), refer to the flow arrow embossed on the pressure
limiting valve to determine inlet.
•
The Pressure Limiting Valve must be installed in the system before the
purifier, this is to protect against water hammer or pressure surges from
the water supply (which could crack the purifier if left unprotected).
Note: Failure to install the Pressure Limiting Valve will void your warranty.
•
Cut lengths of tubing to connect the Pipe tap (or C-Clamp) to the
Pressure Limiting Valve and the Pressure Limiting Valve to the Purifier.
Cut a further length of tubing to connect the Purifier to the tap. It is
important to ensure that when you cut the tubing the cuts are clean and
square to avoid leaks. When connecting push the end of the tubing firmly
into the end of each component. If you can remove the tubing without
any force, then the tubing is not connected.
•
If you have used a C-Clamp as part of the installation, connect the tubing
to the outlet of the C-Clamp, turn on the household water then slowly
turn the valve tap on the C-Clamp anti-clock wise allowing water to flow
through the tubing into a bucket or container. This will ensure any copper/
plastic pieces that have entered the pipework during the attaching of the
C-Clamp are flushed away. Turn off the household water and complete the
connection of the tubing following the instructions above.
Содержание microlene
Страница 6: ...Notes ...
Страница 7: ......