3
1. FOREWARD
The Davey heat pump uses eco-friendly R32 gas and step-less DC inverter technology which allows heat to
be extracted from the surrounding air more efficiently. This heat is transferred to the pool water by a twisted
titanium heat exchanger. This method generates substantial energy savings compared to: a conventional
electric resistance heater, and natural, or propane gas pool heaters.
2. SAFETY PRECAUTIONS
We have provided important safety messages in this manual and on your heat pump.
Please always read and obey all safety messages.
Environmentally friendly R32 Refrigerant is used for this heat pump.
2.1 Warning
WARNING: Low velocity burning material.
R32 Gas
The WARNING sign denotes a hazard. It calls attention to a procedure, practice,
or the like, which, if not correctly performed or adhered to, could result in personal
injury or injury to a third party. These signs are rare, but are extremely important.
WARNING: Do not use means to accelerate the defrosting process or to clean other than
those recommended by the manufacturer.
The appliance shall not be stored near any ignition sources (for example; open flames, an
operating gas appliance or an operating electric heater.
Do not pierce or burn.
Be aware that refrigerants may not contain an odour.
R32 Gas
INSTALLATION REMINDERS:
The installation of any pipework should be kept to a minimum.
Pipework should be protected from physical damage and shall not be installed in an
unventilated place.
The heat pump should not be installed indoor.
Any mechanical connections need to be kept accessible for maintenance purposes.
The heat pump requires 50cm clear space on each side to be clear from obstructions for
ventilation purposes.
Any maintenace or service needs to be carried out in compliance with national
gas regulations.
QUALIFICATION OF WORKERS: A technician with a Refrigerant Handling Licence should
carry out any service or maintenance carried out on the heat pump refrigerant equipment.
A registered electrician should carry out any service or maintenance required for the heat
pump electrical equipment.
2.2 Attention
a. Please read the following instructions before installation, use and maintenance.
b. Installation must be done by professional staff only in accordance with this manual and any
local regulations.
c. Leakage test must be performed after installation.
d. Please don’t stack substances, which will block air flow near inlet or outlet area, otherwise the efficiency of
the heat pump will be reduced or even stopped.
