PLEASE READ THE INSTRUCTIONS ON THE REVERSE BEFORE YOU BEGIN INSTALLING YOUR LIGHT
230V ac 50Hz
Installation Diagram
Inserting & Replacing Lamp (Bulb)
IP54
Installation and Assembly Instructions
7601
Low Voltage Recessed Step Light
With Back Box
To Insert/Replace Light bulb
Ensure power is turned off and lamp is left to
cool before replacing
- Squeeze the rear reflector at the top and
bottom (A)
- Pull away from the cover/lamp assembly (B)
- To fit the lamp, ease lamp into lampholder
with a gentle rocking motion (C)
- Replace reflector by squeezing at the top and
bottom, locating the slots into the tabs (B)
Tabs
Slots
A
B
C
Refer to diagrams below.
- Using appropriate tools, make a cut out in the wall where the light is to be installed.
- When creating cut-out hole, it is essential that two notches are made to accommodate the protruding hank
bushes that accept the fixing screws (F).
- Follow diagrams A, B and C to insert bulb.
- Remove the nut from the gland on the underside of the box and slide over the supply cable (must be round
flex, diameter 6-10mm). Pass the cable up through the gland until you have enough length to reach the
connector, screw the nut back on and tighten.
- Having made the electrical connection, the fitting can be inserted into the cut out by fully squeezing the leaf
springs (D) and locating into the cut-out (E), allowing the leaf springs to hold it securely in position. Secure
step light into back box using screws (F).
D
E
F
65mm x 65mm x 125mm deep hole
Gland
Connector
Hank bushes
G4
CAPSULE
LAMP GUIDANCE
TYPE*
WATTAGE**
BASE
SHAPE
HALOGEN
LED
20W MAX
3W
* Warm white (2700k) low energy lamps recommended.
** Wattage value provided as a guide to suitable lamps. Lower wattage than stated may be used.
