5
Setting Up
2
1
13cm
A
-/+ 45° continuous
B
(or M8x40 screw)
ergo_memo-card2
Protection
slider
18 levels
Vertical adjustment
Loosen the spring loaded tommy head button
2
by one to two turns, and then
pull it out. Move the saddle column up or down to the required height. Release
the tommy head button and move the saddle column a little bit up or down until
the protruding red safety button on the tommy head button locks in. Then tighten
the tommy head button.
For safety reasons height adjustment is only possible up to level 18!
safety button
Handlebars adjustment
Loosen slightly the articulation (hinge) of the handlebars column (with allen
wrench no 10). You can now swivel the complete handlebars and dashboard
unit into the required position. Then tighten the hinge again.
Loosen the handlebars with star knob B as appropriate for its set position, turn
it to the required position and tighten it back.
(Please use the supplied M8x40 screw in place of the star knob B if the handlebars
is subjected to a heavy load, e.g. in the case where you pedal standing on the
pedals and laying your weight on the handlebars.)
You can adjust position of the dashboard in the same way by means of the
tommy screw A.
Switching ON / Off
Please read the safety notes before switching the ergo_bike premium8i on, and
follow the installation and assembly instructions.
Insert the ergo_memo-card2 in the dashboard before switching the device on.
Use the On/Off switch " I " on the lower rear section of the device to switch it
on and off.
3
On / Off power switch
Saddle adjustment
Horizontal adjustment
Loosen the lever
1
slide the saddle to the required position and then tighten
the lever again.
The lever should point to the rear after tightening. Pull and turn the lever to point
to the rear.
- risk of injury.
When switched on, the system takes about 1 minute to load the software. The
colour screen displays during this time a software load progress bar.
Wait for the beep signal before using the dashboard.
If the memory card is inserted after the device is switched on then you must
wait for the beep signal. This can take about 5 seconds.
In principle the memory card should be pulled out while you are not pedalling
or only after the beep signal!
The protection slider on the ergo_memo-card2 must point to the bottom when
the card is inserted into the dashboard. This will make it possible to write to the
card.
If the slider points upward the card is locked/write protected.
If the card is empty it will be initialised. Only then can you use a computer to
save e.g. mp3 files (in the \mp3 folder) or update files (in the \update folder) on
the card.
GB
Содержание Premium 8
Страница 1: ...User Manual ...