Datron neo, Инструкции по установке

Страница: 5 / 25

Setting up the machine
Setup site
1
Setup instructions neo
1.21 DATRON AG 1-1
1 Setting up the machine
1.1 Transport
For safe transport to the setup site, the transport route must be
checked. In all areas, make sure that the width, height and load-
bearing capacity are sufficient. Check the following:
■
Entrance and parking options for a truck
■
Access inside the building (stairs, doors, passageways)
■
Stairwells and elevators
■
Floor conditions and surfacing
1.2 Setup site
CAUTION
Building damage due to impermissible load-bearing capacity!
When setting up the machine in residential buildings, the
permissible floor load must be checked by a structural engineer.
■
Here, observe the machine weight (see table in the chapter
"Dimensions and weight" ) and also note that the machine
generates dynamic loads of approx. 500 N with a frequency
from 0 to 5 Hz.
The machine is installed on site on a solid base. The floor of
the installation location must be sufficiently strong, rigid and
smooth. The height of the support feet is adjustable and they
are not screwed to the floor. The machine requires a minimum
all-round clearance to its surroundings to allow access to
components within the casing. See the Technical Data for the
various dimensions.
Also observe the legal regulations on occupational health and
safety and escape routes.
CAUTION
Risks of using cooling lubricants!
Flammable vapours may be generated when using cooling
lubricants.
■
Open flames, smoking, eating and drinking are prohibited in
the vicinity of the machine.
■
The safety instructions of the manufacturer of the cooling
lubricant and material must be observed!