Dato LJS6035, Руководство пользователя, Страница: 17 / 29

USER ’ S MANUAL
17
Chapter 5 ADJUSTMENT
Add oil and check the order of phase .
After installing lift as Picture 4 required and connecting hydraulic circuit, electric
circuit and air loop, operate it as following:
-Open the hydraulic oil tank; add 18L of hydraulic oil into the oil tank, the hydraulic oil is
prepared by the user.
Make sure the clean of hydraulic oil, prevent any impurity into the oil line, lead the
digest of the oil line and no working of the solenoid air valve.
-
Turn the “MAIN SWITCH” on power, click the “UP” button, and check whether
the motor turns clockwise (looking downward); if not turn off the power, change
the phase of the motor.
-Turn on air power.
When turn on power, the high voltage will exist in the control box, only authorized person can
operate it.
Main machine oil make-up adjustment
1 Press ‘UP’ button, and then motor starts to lift two platforms to
go up to the apex.
2 Open the door of control box, and press 'UP' button and button
as right side picture inside the control box for some minutes.
3 Press ‘DOWN’ button to let the two platforms go down until the platforms are lowered to
the bottom , and the platforms will go down to the lowest position.
4 The oil make-up adjustment process is over.
Check : oil leakage of the oil line and air tightness of the air loop.
Chapter 5 ADJUSTMENT
GROUND BOLTS INSTALLATION:
The ground bolts installation must start after the expiry date on the maintenance of
concert, otherwise, it will affect the quality of solidity.
-Adjust the parallel of the platform and the distance of two platforms as Picture 4
requires.
-
Fix the anchor bolts with a percussion electric drill (percussion drill bit is of 16),
drill to 120mm hole and clean the hole.