Dateq SPL 2, Руководство пользователя, Страница: 22 / 54

6 Installation SPL2(TS) and SPL3(TS) user manual EN
Connectors
To prevent modification of the connections after calibration and sealing, the connectors of the
limiter are inaccessible after sealing of the cover plates at the front. To access the connector
board, remove the right cover plate at the front panel.
Unfasten screw (A) with a torx-screwdriver (see illustration). Now remove the 4 torx-screws (B)
from the top lid. The top cover can be removed now. Gently lift the front side a little, and slowly
shift the lop lid to the rear. The connector board will become visible.
CHECK USER MANUAL O R
WWW.DATEQ.NL
FO R OPERATION AND MAINTENANCE DETAILS
SERIAL INTERFACE AUDIO OUTPUTS AUDIO INPUTS MIC INPUT
1 13
14 25
SPL3(TS) only L - R L - R
IN
OUT
100-240VAC
POWER
2011
RoHS
CO MPLI A NT
2 8 0 0 / / 5 9 EC
MADE IN THE NETHERLANDS
LIMITER
Stereo Program Audio Limiter
AUDIO XLR
1 Ground
2 Audio +
3 Audio -
SERIAL INTERFACE
1 Ext Attenuation In
2 Reduction
3 Overload
4 *Warning
5 *Live Mode OK
6-8 Ground
9 *Mic In +
10 Left In +
11 Right In +
12 Left Out +
13 Right Out+
18 I/O TXD
19 I/O RXD
14-17, 20 Ground
21 *Mic In -
22 Left In -
23 Right In -
24 Left Out -
25 Right Out -
*SPL3(TS) only
SERIAL NUMBER
CAUTION
DISCONNECT POWER CABLE
BEFORE OPENING.
RISK OF ELECTRIC SHOCK.
Mike Input (only use the original DATEQ-microphone) (XLR 3-pins female)
Pin Function Type
1 Ground A-GND
2 Audio + In
3 Audio - In
Audio in Left / Right (balanced XLR 3-pins female)
Pin Function Type
1 Ground A-GND
2 Audio + In
3 Audio - In
Audio out Left / Right (balanced XLR 3-pins male)
Pin Function Type
1 Ground A-GND
2 Audio + Out
3 Audio - Out